Allied Telesis AT-S97 - Manual (Page 85)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
85
SYSTEM SET INTERFACE PORTNAME
Syntax
system set interface id= c|b|pp portname=string
Parameters
id Specifies a media converter module or a channel. The ID
consists of the following parts:
c Identifies the ID number of the chassis. The
chassis ID number depends on which module is
installed in the management slot of the chassis.
When a management module is installed in this
slot, the chassis ID number is 0 or 31. When a
stacking module is installed in this slot, the
chassis ID can be from 1 to 30.
b Specifies the ID number of the line card.
Possible values are:
1 - 4 Specifies a slot number of a media
converter module. In the
AT-MCF2000 Chassis, the left slot is
1 and the right slot is 2.
pp Specifies the port pair. There are 12 port pairs
per module. Choose a value between 1 and 12.
You cannot specify more than one port pair.
portname Specifies a port name of up to 20 alphanumeric characters.
Privilege Levels
Administrator and read-write.
General Description
This command allows you to name each port pair in the chassis. A port
pair consists of both the twisted pair port and the fiber optic port for the
specified port number.
Example
This command sets the name of the port pair 7 (for both the twisted pair
port 7 and the fiber optic port 7) on module 2 in chassis 1 to “Lamborghini:”
system set interface id=1/2/7 portname=Lamborghini