Allied Telesis AT-S97 - Manual (Page 101)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
101
SYSTEM SHOW INTERFACE
Syntax - Chassis Only
system show interface id= chassis
Syntax - Chassis and Slot
system show interface id= chassis / slot
Syntax - Chassis, Slot and Channel
system show interface id= chassis / slot / channel
Parameters
id Specifies the chassis, slot or channel to display. The
command can display only one device at a time. The ID
consists of the following parts:
chassis Identifies the ID number of the chassis. The
chassis ID number depends on which module is
installed in the management slot of the chassis.
When a management module is installed in this
slot, the chassis ID number is either 0 or 31.
When a stacking module is installed in this slot,
the range of the chassis ID is from 1 to 30.
slot Specifies the slot number of the media converter
module with the port. Possible values are:
1 or 2 Specifies a slot number of a media
converter slot. In the AT-MCF2000
Chassis, the left slot is 1 and the right
slot is 2.
channel Specifies the number of a channel on the
AT-MCF2012LC and AT-MCF2012LC/1
Modules. You can specify only one channel at a
time. Possible values are:
1 to 12 Specifies a channel. Channel 1
consists of twisted pair port 1 and
fiber topic port 1, channel 2 of twisted
pair port 2 and fiber topic port 2, and
so on.
To view the ID and slot numbers of a chassis, refer to
“SYSTEM SHOW CLUSTER” on page 99 or “SYSTEM
SHOW CHASSIS” on page 96.