Allied Telesis AT-S97 - Manual (Page 203)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
203
Activities that generate the SNMP traps are listed below:
ˆ module has been installed or removed
ˆ port link status is offline or online
ˆ port link status is RX (receive) SML or TX (transmit) SML
ˆ port operational mode is changed to Missing Link or SML
ˆ port operational mode is changed to OAM Bypass, OAM visible, or link
test
ˆ TFTP session is opened or closed
ˆ XMODEM session is opened or closed
ˆ TELNET session is opened or closed
ˆ TELNET server is enabled or disabled
ˆ SSH session is opened or closed
ˆ SSH session is enabled or disabled
ˆ warm or cold boot of a media converter module
ˆ management stacking port is up or down
ˆ a module was acquired by or released by the chassis management
ˆ login authentication failure
ˆ Fan A failure or recovery on either power module or AT-MCF2KFAN
fan
ˆ Fan B failure or recovery on either power module or AT-MCF2KFAN
fan
ˆ power failure or recovery on a power module
ˆ chassis has been reset
ˆ module has been reset
ˆ low battery or recovery from low battery
ˆ management module has overwritten media converter module
configuration
ˆ media converter module has overwritten management module
configuration
Trap receivers are the devices, typically management workstations or
servers, that you want to receive the traps sent by the unit. You specify the
trap receivers by their IP addresses. You assign the IP addresses to the
community strings.
Each community string can have up to four trap IP addresses.