Allied Telesis AT-S97 - Manual (Page 102)

Chapter 6: Port and Module Commands
102
Privilege Levels
Administrator, read-write, and read-only.
General Description
This command can display a variety of status information about a media
converter chassis and the media converter modules. You can limit the
information to just the model names of the media converter modules in a
chassis or view more detailed information about the devices, such as the
current operating parameters of the two ports of a media converter
channel.
Note
To view the parameter settings of the 10/100/1000Base-T port on
the AT-MCF2000M Management Module, use the SYSTEM SHOW
MODULE command. For information, refer to “SYSTEM SHOW
MODULE” on page 108.)
Description of the Chassis Only Command
Specifying just a chassis ID number in the command displays the names
of the media converter models in a chassis and their respective slot
numbers. This is useful in determining the types of media converter
modules in a chassis. An example of the information is shown in
Figure 13.
Figure 13. SYSTEM SHOW INTERFACE Command - Chassis ID Only
The table does not include empty media converter slots. The columns in
the table are defined here:
ˆ Chassis ID - The chassis ID number.
ˆ Slot ID - The slot numbers of the media converter modules in the
chassis. In the AT-MCF2000 Chassis, the left slot is 1 and the right slot
is 2.
ˆ Module Name - The module’s name. To assign a name, refer to
“SYSTEM SET MODULE” on page 86.
ˆ Module Type - The module’s model name.
Interface 0 Information:
Chassis ID
Slot ID Module Name Module Type
----------------------------------------------------
1 1 Traffic 12 AT-MCF2012LC
1 2 Traffic 7 AT-MCF2012LC