Allied Telesis AT-S97 - Manual (Page 19)

AT-S85 and AT-S97 Management Software Command Line Interface User’s Guide
19
The ID number for a chassis is set with a jumper on the management
module, shown in Figure 1 on page 18. The chassis ID number for a
management module is either 0 or 31. The default setting is 0.
Within a stack, you assign the management module on the master unit
with a chassis ID of 0. You assign all of the AT-MCF2000S Stacking
modules on the slave chassis with a chassis ID of 1 through 30. For more
information about stacking, see Chapter 2, “Stacking” on page 35.
To view the ID number of a chassis, issue this command:
system show cluster
For further information, see “Displaying the Chassis Modules” on page 28
or “SYSTEM SHOW CLUSTER” on page 99.