Ip show, Figure 7: ip show command – Allied Telesis AT-S97 User Manual
Page 54
Chapter 4: IP Configuration Commands
54
IP SHOW
Syntax
ip show
Parameters
None.
Privilege Levels
Administrator, read-write, and read-only.
Description
This command displays the management module’s IP address, subnet
mask, and default gateway address, as shown in Figure 7.
Figure 7. IP SHOW Command
For further information, refer to the following sections:
“Overview” on page 48 for background information on when to assign
an IP configuration to the management module.
“IP SET” on page 52 for instructions on how to manually assign these
values.
“IP DHCP DISABLE” on page 50 for instructions on how to activate the
DHCP and BOOTP clients.
Example
ip show
IP Information:
IP Address........... 149.25.42.11
Subnet Mask.......... 255.255.255.0
Gateway.............. 149.25.42.27
DHCP................. Disable