Allied Telesis AT-S97 - Manual (Page 195)

195
Chapter 11
Telnet Server Commands
This chapter describes commands that control the management module’s
Telnet application protocol server. This chapter contains the following
sections:
ˆ “Overview” on page 196
ˆ “TELNET DISABLE” on page 198
ˆ “TELNET ENABLE” on page 199
ˆ “TELNET SHOW” on page 200
Note
Remember to save your parameters changes in the active master
configuration file with the CONFIG SAVE command. For information,
refer to “Saving Your Configuration Changes” on page 17 or
“CONFIG SAVE” on page 157.