HP 3PAR Operating System Software - Manual (Page 95)

The following information is provided:
Description Field Group
Port location. Location General
Port World Wide Name. Port WWN
Node World Wide Name. Node WWN
Indicates whether the port is FC, iSCSI, RCIP,
or RCFC. Type
Rate that data can be transferred over the port
(1 Gbps, 2 Gbps or 4 Gbps). When there is
no specified value, no connection exists. Rate
Type of device that the port is connected to.
Free, Disk, Host, Peer, or InServ. Connected Device Type
Name of device that the port is connected to,
e.g. host1, cage0. Connected Device
Port firmware mode setting. Ports in Initiator
mode are connected to drive cages and ports Mode
in Target mode export to hosts. Suspended
mode is for target ports that have not yet been
initialized by the system (rare). Peer mode is
for Ethernet ports.
Current state of the port. State
The throughput in KB/sec. Total Data Throughput Resources
The type of port connection. Connection Mode Settings
Connection type or port connection setting
(Loop, Point, or Loop-point). When the port is Connection Type
set to Loop-point, both loop and point-to-point
connections are enabled.
Data transfer rate setting (for example, 1
Gbps). Auto indicates that the system
automatically selects the rate. Configured Rate
Maximum rate of connection from the port. Max Rate
Indicates whether Fibre Channel service Class
2 is Disabled, Ack 1 or Ack 0. Class 2
Viewing System Ports 95