HP 3PAR Operating System Software - Manual (Page 62)

18 Editing a System
You can edit the identification, identification information, properties, and alert settings for any
system connected to the InForm Management Console.
NOTE: Editing systems can only be performed by users with Super, Service, and Edit privilege
levels.
To edit a system, access the Edit System wizard.
1.
In the Manager Pane, click Systems.
2. In the Management Tree, click the system you wish to edit.
3. In the Common Actions Panel, click Edit System.
The Edit System wizard appears.
In the Edit System wizard, edit the following information as needed:
1.
In the General group box, select the following:
a.
Name - enter a new system name.
b. FC Raw Space Alert - Select whether to enable or disable the raw space alert for Fiber
Channel drives. If Enabled, enter a value from 100 to 100,000 GiB.
c. NL Raw Space Alert - Select whether to enable or disable the raw space alert for Nearline
drives. If Enabled, enter a value from 100 to 100,000 GiB.
d. SSD Raw Space Alert - Select whether to enable or disable the raw space alert for SSD
drives. If Enabled, enter a value from 100 to 100,000 GiB.
NOTE: These fields only appear for devices installed on the system. For example, if
your system contains no SSD drives, the SSD Raw Space Alert field will not be present.
e. Select whether to enable or disable the Copy Space Reclaim feature, which reclaims
logical disk space.
f. To select a Maximum Volume Retention time, select Enabled, select hour(s) or day(s), and
then enter a value of 1 to 1,825 (days) or 1 to 43,800 (hours).
2. In the Descriptors group box, enter the following:
a.
Location - Enter the physical location of the storage system; for example, Lab 1.
b. Owner - Enter the owner of the storage system.
c. Contact - Enter any contact information.
d. Comments - Enter any relevant notes about the storage system.
3. Click OK.
The storage system is updated accordingly.
62 Editing a System