HP 3PAR Operating System Software - Manual (Page 89)

Description Field Group
Indicates whether port mode change from initiator to target or vice versa
is Allowed or Prohibited. This setting is configured using the InForm CLI
command controlport. Mode Change
The number of hosts connected to the port. This is only displayed if the
port is connected to hosts. Hosts
The number of physical disks connected to the port. This is only displayed
if the port is connected to drive cages. Physical Disks
The current state of the link. Displayed if the port is an RCFC port. Link State
The node WWN. Displayed if the port is an RCFC port. Remote Node WWN
The port WWN. Displayed if the port is an RCFC port. Remote Port WWN
Primary Internet Storage Name Service (iSNS) server IP address. iSNS
protocol allows for automated discovery, management, and configuration
of iSCSI. Primary IP Address iSNS Settings
(displayed for iSCSI
ports - not shown)
Secondary iSNS server IP address. Secondary IP Address
The port on the iSNS server with which to communicate. TCP Port
Physical Disks
The physical disk port information is presented on the Physical Disks tab.
The following information is provided:
Description Column
The arbitrated loop physical address of the device. AL_PA
The type of connected disk. Device
The position of the disk in the system. Position
The number of errors on the connected disk. I/O Error Count
The state of the disk. See “System and Component Status Icons” (page 41)
.
State
SFP
The port SFP information is presented on the SFP tab.
Viewing System Ports 89