Rc ports tab – HP 3PAR Operating System Software User Manual
Page 241
Access the Available InServs screen and then click the numeric value under the RCFC, RCIP, or
Total column.
or
1.
In the Manager Pane, click Remote Copy.
2.
In the Management Tree, under Available InServs, click the Ports node under the system whose
Remote Copy ports you wish to view.
Information about a system's Remote Copy ports is displayed on four tabs, RC Ports, RCIP, RCFC,
and Inventory.
RC Ports Tab
The RC Ports tab displays a summary of all Remote Copy ports on a system.
The upper pane of the RC Ports tab displays summary information about the system's Remote Copy
ports. The lower pane displays details about a selected port from the upper pane.
The following information is displayed in the upper pane:
Description
Column
The location of the port in node:slot:port format.
Position
The World Wide Name (WWN) or Media Access Control (MAC) address of the
connected device.
WWN/MAC
The state of the port. See
“System and Component Status Icons” (page 41)
.
State
The type of port, either Remote Copy over IP (RCIP) or Remote Copy over Fibre Channel
(RCFC).
Type
Type of device that the port is connected to. Free, Disk, Host, Peer, or InServ.
Connected Device Type
Name of device that the port is connected to, e.g. host1, cage0.
Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to drive cages and
ports in Target mode export to hosts. Suspended mode is for target ports that have not
yet been initialized by the system (rare). Peer mode is for Ethernet ports.
Mode
For information about the lower pane, see
and
.
Viewing Remote Copy System Ports
241