HP 3PAR Operating System Software - Manual (Page 115)

2. Right-click the port you wish to sync and then click Name Server Sync in the menu that appears.
The Name Server Sync dialog box appears.
3. Click Yes.
Issuing an LIP Command
NOTE: This operation can only be performed on Fibre Channel and Remote Copy over Fibre
Channel (RCFC) ports.
To issue an LIP command:
1.
Access the ports Summary tab.
2. Right-click the port on which you wish to issue the LIP command and then click Issue LIP in the
menu that appears.
The Issue LIP dialog box appears.
3. Click Yes.
Enabling a Remote Copy Interface
NOTE: This operation can only be performed on Remote Copy over IP (RCIP) ports.
To enable a Remote Copy interface:
1.
Access the ports Summary tab.
2. Right-click the disabled Remote Copy port you wish to enable and then click Enable Interface
in the menu that appears.
The Enable Interface dialog box appears.
3. Click Yes.
Disabling a Remote Copy Interface
NOTE: This operation can only be performed on Remote Copy over IP (RCIP) ports.
To disable a Remote Copy interface:
1.
Access the ports Summary tab.
2. Right-click the Remote Copy port you wish to disable and then click Disable Interface in the
menu that appears.
The Disable Interface dialog box appears.
3. Click Yes.
Pinging a Port
To ping an iSCSI or RCIP port:
1.
Access the ports Summary tab.
2. Right-click the iSCSI or RCIP port you wish to ping and then click Ping in the menu that appears.
The Ping Port wizard appears.
3. In the General group box, enter the following:
a.
System - Select a system from the list.
b. Port - Select the port from which you are initiating the ping.
c. Destination IP Address - Enter the destination port's IP address.
d. Count - The number of times (from 1 to 25) to ping the specified IP address.
e.
1
Wait Time - Enter the wait time in seconds (5 to 30) for each ping.
1. For RCIP ports only.
Issuing an LIP Command 115