HP 3PAR Operating System Software - Manual (Page 108)

The SFPs tab is divided into an upper pane and a lower pane. The upper pane displays a summary
of all SFPs in the system. The lower pane displays detailed information about a single SFP selected
from the upper pane.
The upper pane provides the following information:
Description Column
Position of the port in which the SFP is installed. Position
The drive cage state. See “System and Component Status Icons” (page 41) . State
The SFP manufacturer. Manufacturer
The SFP's part number. Part Number
The SFP's serial number. Serial Number
The revision level of the SFP. Revision
Maximum speed allowed by the SFP. Max Speed
Displays whether the SFP has been qualified by 3PAR. Qualified
Displays whether the transmit laser is disabled. TX Disable
Displays whether the transmit laser has a problem. TX Fault
Displays whether the receive end of the SFP is experiencing a loss of signal from
the host or drive cage. RX Loss
Displays whether the SFP receive power is low. RX Power Low
Displays whether the SFP is DDM-capable (Digital Diagnostic Monitoring). DDM Support
108 Working with Ports