HP 3PAR Operating System Software - Manual (Page 88)

Description Field Group
For iSCSI ports. The Media Access Control address for the Ethernet
interface. MAC (not shown)
For iSCSI ports. The Target Portal Group Tag for the iSCSI target portal
group. TPGT (not shown)
The throughput in KB/sec. Total Data Throughput Resources
The type of port connection. Connection Mode Settings displayed
for FC and RCFC
ports)
Connection type or port connection setting (Loop, Point, or Loop-point).
When the port is set to Loop-point, both loop and point-to-point
connections are enabled. Connection Type
Data transfer rate setting (for example, 1 Gbps). Auto indicates that the
system automatically selects the rate. Configured Rate
Maximum rate of connection from the port. Max Rate
Indicates whether Fibre Channel service Class 2 is Disabled, Ack 1 or
Ack 0. Class 2
For fabric attached ports, indicates the VLUN change notification setting.
When set to Enabled, notices are generated and sent to the fabric
controller. When set to Disabled, no notification is sent. VCN
Indicates whether the node's WWN is Enabled or Disabled. Unique Node WWN
If disabled, each I/O generates a separate interrupt to the HBA port
driver rather than generating one interrupt for multiple I/O completion. Interrupt Coalesce
For RCIP ports. Media Access Control address of the Ethernet interface. MAC IP Settings
(displayed for RCIP
For iSCSI ports. Indicates if the Dynamic Host Configuration Protocol
(DHCP) protocol is enabled. DHCP
and iSCI ports - not
shown)
IP address of the iSCSI or RCIP port. IP Address
The address of a local IP router on the same network as the system, used
to forward traffic to destinations beyond the local network. Gateway
Netmask address for the iSCSI or RCIP interface. Subnet Mask
Maximum Transmission Unit. The greatest amount of data or "packet"
size that can be transferred in one physical frame on a network. MTU MTU
setting for the iSCSI port. The default setting is 1500. When supported
by the network, an MTU value of 9000 should be used.
For RCIP ports. The configured data transfer rate. A value of 0 indicates
that no data is being transferred. Configured Rate
For iSCSI ports. Data transfer rate. A value of 0 indicates that no data is
being transferred. Rate
The TCP port number used by the iSCSI card. TCP Port
(For RCIP) The duplex speed, Half or Full. Duplex
For RCIP ports. Model of the adapter that contains the port (for example,
Intel PRO/1000MT). Adapter Type
Type of connection (Private Loop, Public Loop, or Point-Point). Topology Fibre Channel
Settings
Identifies which Fibre Channel classes of service are enabled (2, 3, or
2/3). 2/3 indicates that both Class 2 and Class 3 are enabled. Class
(displayed for FC
and RCFC ports)
Model of the Fibre Channel adapter that contains the port (for example,
QLOGIC 2302). Adaptor Type
88 Working with Ports