HP Surestore Disk Array 12h and FC60 - Manual (Page 393)

Disk Enclosure Modules 393
Re
m
o
v
a
l a
n
d
R
ep
lac
eme
n
t
Figure 97 Disk Enclosure Fan Module Removal and Replacement
Installing the Fan Module
1. Slide the replacement fan module into the empty slot (C in Figure 97 ).
2. Tighten the locking screws (A).
3. Check the fan module LED for the following behavior:
– The Fan Fault LED should flash amber, and then turn green after a few seconds. If
the LED does not turn green, refer to "Troubleshooting" on page 359 .
B
A - Locking screw
B - Pull tab