HP Surestore Disk Array 12h and FC60 - Manual (Page 290)

290 Managing the Disk Array Using Array Manager 60
• RAIDlevel - RAID level used for the LUN. Valid RAID levels are 0, 1, and 5. RAID 0 support
requires firmware version HP08 or later. A RAID 0/1 LUN is created by selecting RAID 1
with more than two disks.
• - options giving you control over how the LUN is configured. Table 38 lists
valid options and what they do.
Note
After binding a LUN, you must execute the
insf -e
command to install special
device files for the LUN. This makes the LUN usable by the operating system.
Table 38 Command Options for Binding a LUN
Option Description Default
-c capacity Specifies the capacity of the LUN. Capacity
can be specified in megabytes (M) or
gigabytes (G) by appending the appropriate
letter to the capacity value.
By default, the LUN will use the entire
capacity available from all the disks. It is
possible to specify a lower value for LUN
capacity, but this will result in unused disk
capacity. Any capacity not included in the
LUN will be inaccessible and is essentially
wasted capacity.
If not specified, the LUN capacity
will equal the total available
capacity of the specified disks.
If a capacity value is specified but
no letter is appended, gigabytes will
be assumed.