HP Surestore Disk Array 12h and FC60 - Manual (Page 286)

286 Managing the Disk Array Using Array Manager 60
Information for Controller A - 000A00A0B80673A6:
Controller Status = GOOD
Controller Mode = ACTIVE
Vendor ID = HP
Product ID = A5277A
Serial Number = 1T00310110
Firmware Revision = 04000304
Boot Revision = 04000200
HP Revision = HP08
Loop ID = 5
AL_PA = 0xE0
Preferred AL_PA = 0xE0
Controller Date = 05/08/2000
Controller Time = 13:38:53
Cache Battery Age = 0 to 89 days
NVSRAM Checksum = 0x353181DF
Information for Controller B - 000A00A0B80673A6:
Controller Status = GOOD
Controller Mode = ACTIVE
Vendor ID = HP
Product ID = A5277A
Serial Number = 1T90510188
Firmware Revision = 04000304
Boot Revision = 04000200
HP Revision = HP08
Loop ID = 4
AL_PA = 0xE1
Preferred AL_PA = 0xE1
Controller Date = 05/08/2000
Controller Time = 13:38:54
Cache Battery Age = 0 to 89 days
NVSRAM Checksum = 0x353181DF
Information for Disk System 1 (USSA02010592), Controller B:
SCSI Channel = 2
Thumbwheel Setting = 0
Controller Status = GOOD
Vendor ID = HP
Product ID = A5294A
Serial Number = USSA02010649
Firmware Revision = HP04
Information for Disk System 1 (USSA02010592), Controller A:
SCSI Channel = 1
Thumbwheel Setting = 0
Controller Status = GOOD
Vendor ID = HP
Product ID = A5294A
Serial Number = USSA02010592
i i i
Controller Information - make sure the
following conditions are met:
- Both controllers should be ACTIVE
- The Loop ID must be unique for each
controller
- The three levels of firmware revisions must
be identical for each controller
Disk Enclosure Information -
make sure the following
conditions are met:
- The status of both controllers
(BCCs) should be GOOD
- The Thumbwheel Setting
must be the same for each
controller
- The Thumbwheel Setting
should correspond to the
enclosure position in the rack.
Uppermost enclosure set to 0,
next one down set to 1, etc.