HP Surestore Disk Array 12h and FC60 - Manual (Page 282)

282 Managing the Disk Array Using Array Manager 60
Checking Disk Array Status
An important part of managing the disk array involves monitoring its status to ensure it is
working properly. Changes in disk array status may indicate a possible hardware failure, so
it is important to check disk array status regularly.
All aspects of disk array operation are continually monitored and the current status is
stored for viewing. You can selectively view the status of any portion of the disk array
configuration.
See "Status Conditions and Sense Code Information" on page 317 for assistance in
interpreting status information.
Displaying Status Information
To display status information, type:
amdsp
• option identifies the type of status information to display. Table 37 lists the command
options and the status information each displays.
Table 37 Command Options for Displaying Disk Array Status
Option Status Information Displayed
none General array information. This includes disk capacity usage.
Sample output is shown in
Figure 88
.
-l [LUN] LUN status. Status for all LUNs on the disk array will be displayed,
unless a specific LUN is specified using the LUN option. If UTM is
enabled, it will be displayed in the LUN output.
-g Disk group status.
-d Disk status. Complete information will be displayed for each disk in
the disk array.
-c Controller status. Information is displayed for both disk array
controllers and for all disk system BCC modules.
-s Array status. Information about the entire array is displayed.
-h Hardware status. Information is displayed for all disk array hardware
components, including fans and power supplies.