HP Surestore Disk Array 12h and FC60 - Manual (Page 405)

Controller Enclosure Modules 405
Re
m
o
v
a
l a
n
d
R
ep
lac
eme
n
t
Power Supply Module Removal/Replacement
!
Hot Swappable Component!
A power supply should be replaced as quickly as possible to avoid the possibility of the
remaining supply failing and shutting down the disk array.
Removing the Power Supply Module
1. Turn off the power switch and unplug the power cord from the failed power supply
module. See Figure 104 .
2. Lift up on the pull ring to release the latch. See Figure 105 .
3. Slide the supply out of the enclosure.
Figure 104 Removing Power from the Controller Enclosure
A
Power Switch