beautypg.com

2 requirements for outputting audit log data – HP Hitachi Dynamic Link Manager Software User Manual

Page 70

background image

2. HDLM Functions

48

#1

The severity levels are as follows:
3: Error, 4: Warning, 6: Informational

#2

If you use Ctrl + C to cancel the

DLMgetras

utility for collecting HDLM error

information, audit log data indicating that the

DLMgetras

utility has terminated

will not be output.

#3

If you use Ctrl + C to cancel the

dlmgetrasinst

utility for collecting HDLM

installation error information, audit log data indicating that the

dlmgetrasinst

utility has terminated will not be output.

2.11.2 Requirements for Outputting Audit Log Data

HDLM can output audit log data when all of the following conditions are satisfied:

The

syslog

daemon is active.

The output of audit log data has been enabled by using the HDLM command's

set

operation.

However, audit log data might still be output regardless of the above conditions if, for
example, an HDLM utility is executed from external media.

#

#:

The following audit log data is output:

Categories:

StartStop

,

Authentication

, and

ConfigurationAccess

Severity: 6 (Critical, Error, Warning, or Informational)
Destination: syslog (facility value:

user

)

Note:

Enable

syslog

since

syslog

is disabled by default in AIX.

Processing of the

dlmchpdattr -a

command was successful.

6

KAPL15082-I

Processing of the

dlmchpdattr -a

command failed.

3

KAPL15083-E

Category

Explanation

Audit event

Severity

#1

Message ID