HP Hitachi Dynamic Link Manager Software - Manual (Page 109)

3. Creating an HDLM Environment
87
hdisk3 Available 1H-08-02 Hitachi Disk Array (Fibre)
hdisk4 Available 1H-08-02 Hitachi Disk Array (Fibre)
...
Make sure that the status of all displayed hdisks is
Available
.
hdisks 0 to 2 are the physical device file names for the host's internal disks.
hdisk 3 and the following are the logical device file names that correspond to
physical volumes in the storage system.
22. Execute the
dlnkmgr
command's
view
operation to check the status of each
program:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version :
x.x.x
-
xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(60)
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive
x.x.x
-
xx yyyy
/
mm
/
dd hh
:
mm
:
ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive
x.x.x
-
xx yyyy
/
mm
/
dd hh
:
mm
:
ss
4000
HDLM Driver Ver WakeupTime
Alive
x.x.x
-
xx yyyy
/
mm
/
dd hh
:
mm
:
ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time =
yyyy
/
mm
/
dd hh
:
mm
:
ss
Even if cluster software is used, the name of the cluster software is not displayed
in
Support Cluster
. However, the cluster support function is operating
normally.
23. From the execution result of the
view
operation, check that the correct version of
HDLM is installed.
If
HDLM Version
is x.x.x
-
xx, the installed version of HDLM is correct.