2 preparations for a new installation of hdlm – HP Hitachi Dynamic Link Manager Software User Manual
Page 101

3. Creating an HDLM Environment
79
Table 3-10: Combinations of Migration Methods Available in an HACMP
Environment and the Migration Environments
Legend:
Yes: Can be executed
No: Cannot be executed
N/A: Not applicable
#1
Before you migrate HDLM to an environment that uses HACMP and a virtual I/
O server, cancel the virtual disk definitions of the virtual I/O server. After you
have migrated HDLM, redefine these virtual disk definitions.
#2
Only new installations, upgrade installations, and re-installations are supported.
For details about how to migrate, see each location shown below.
installux.sh
or
installp
command
3.5.6 Migrating from HDLM Version 5.8.1 or Earlier to Version 5.9 or Later, and
(3) Migrating HDLM in an HACMP Environment in 3.5.7 Installing HDLM in
an HACMP Environment.
To use SMIT, see the AIX documentation.
3.5.2 Preparations for a New Installation of HDLM
In this subsection, you will perform such preparations as backing up the HDLM
management-target devices, applying AIX patches, and performing hardware setup.
When using HDLM in a cluster configuration, make sure to perform the operations
Migration method
Migration environment
Host
Virtual I/O server
Local boot disk
environment
Boot disk
environment
Local boot disk
environment
#1
Boot disk
environment
installux.sh
#2
or
installp
command
Yes
N/A
No
N/A
SMIT
Yes
N/A
No
N/A
Unattended installation
No
N/A
No
N/A
Installation on alternate
disks
No
No
No
No