HP Hitachi Dynamic Link Manager Software - Manual (Page 393)

8. Messages
371
Details
Multiple paths will be collectively placed Online because the
-hbaid
or
-chaid
parameter was specified. To collectively place multiple paths Online, enter
y
. To
not collectively place them Online, enter
n
.
aa...aa: CHA, HBA
Action
If you want to execute the Online processing for the paths which pass the
specified target, enter
y
. If you want to terminate the processing, enter
n
.
KAPL01112-E
An attempt to connect to the HDLM driver has failed. Operation
name =
aa...aa
Details
HDLM driver information must be collected to execute the given HDLM
command, but the HDLM driver cannot be accessed.
aa...aa:
clear
,
offline
,
online
,
set
, or
view
Action
Perform one of the following procedures.
When performing an installation
See 3.5 Installing HDLM, and then complete the installation.
When performing an uninstallation
See 3.14.2 Uninstalling HDLM, and then complete the uninstallation.
When performing neither of the above, or if the same error continues to occur
even after one of the above procedures is performed, execute the DLMgetras
utility for collecting HDLM error information, and then contact your HDLM
vendor or the maintenance company if there is a maintenance contract for HDLM.
For details on the
DLMgetras
utility, see 7.2 DLMgetras Utility for Collecting
HDLM Error Information.
KAPL01114-W
The audit log configuration file does not exist. Restart the HDLM
Manager, and execute the "dlnkmgr view -sys -audlog" command and
check the setting.
Details
The audit log configuration file does not exist.
Action