HP Hitachi Dynamic Link Manager Software - Manual (Page 105)

3. Creating an HDLM Environment
83
1. Log in to AIX as the root user.
If you are using a virtual I/O server, see the virtual I/O server documentation to
log in to AIX.
2. If there is no directory for mounting the DVD-ROM, make the directory.
# mkdir /
cdrom
cdrom is the desired directory name. Hereafter, cdrom is used for purposes of
explanation.
3. Mount the DVD-ROM.
# mount -r -v cdrfs /dev/cd0 /
cdrom
The
/dev/cd0
part depends on the system.
4. Execute the following command to check that the devices to be managed by
HDLM have been recognized by the system:
# lsdev -Cc disk
hdisk0 Available 1S-08-00-8,0 16 Bit LVD SCSI Disk Drive
hdisk1 Available 1S-08-00-9,0 16 Bit LVD SCSI Disk Drive
hdisk2 Available 1S-08-00-10,0 16 Bit LVD SCSI Disk Drive
hdisk3 Available 1H-08-02 Hitachi Disk Array (Fibre)
hdisk4 Available 1H-08-02 Hitachi Disk Array (Fibre)
...
In this example,
hdisk3
and
hdisk4
are recognized as devices to be managed
by HDLM. If all devices to be managed by HDLM are recognized, proceed to step
5.
If any devices to be managed by HDLM are not recognized, proceed to step 7.
5. Execute the following utility to remove, from the running kernel, the HDLM
management-target device:
# /cdrom/HDLM_AIX/hdlmtool/dlmrmdev -f
The
KAPL10529-I
message is displayed.
If the
KAPL10529-I
message is not displayed, the HDLM management-target
device has not been deleted. Make sure that no processes, services, file systems,
or volume groups are using any HDLM management-target paths, and then
re-execute the above utility.