HP Hitachi Dynamic Link Manager Software - Manual (Page 131)

3. Creating an HDLM Environment
109
procedure in step 6.
If an upgrade installation ends with an error, HDLM might be uninstalled. In this
case, proceed to step 13.
During installation, the
KAPL09241-W
message might be output. In this case,
installation of HDLM continues, but installation of HDLM components has
failed. After installing HDLM, resolve the problem according to the
KAPL09241-W
message if necessary.
11. For a re-installation, execute the following command:
• When installing HDLM from the DVD-ROM
# /
directory-in-which-the-DVD-ROM-is-mounted
/installux.sh
or
# installp -aXFd
/directory-in-which-the-DVD-ROM-is-mounted
/
HDLM_AIX all
• When installing HDLM from the directory to which the DVD-ROM was
copied
# /
directory-copied-from-DVD-ROM
/installux.sh
or
# installp -aXFd /
directory-copied-from-DVD-ROM
/HDLM_AIX all
Even though a message asking you to restart the host is displayed during
installation, you do not have to restart the host.
If you execute the
dlmrmdev
utility without the
-e
parameter specified at step 6
and then the
KAPL09172-E
message is displayed, the hdisk for the device that is
managed by HDLM still remains.
If you execute the
dlmrmdev
utility with the
-e
parameter specified at step 6 and
then the
KAPL09172-E
message is displayed, the hdisk for the device that is
managed by HDLM still remains, and its status is
Available
. Re-execute the
procedure in step 6.
If re-installation ends with an error, HDLM might be uninstalled. In this case,
proceed to step 13.
During installation, the
KAPL09241-W
message might be output. In this case,
installation of HDLM continues, but installation of HDLM components has
failed. After installing HDLM, resolve the problem according to the
KAPL09241-W
message if necessary.
12. Execute the following command to make sure that the package is installed.
# lslpp -la DLManager.mpio.rte