HP Hitachi Dynamic Link Manager Software - Manual (Page 154)

3. Creating an HDLM Environment
132
# /cdrom/installux.sh -f /
any-directory
/
installation-information-settings-file
To execute
installhdlm
:
# /cdrom/HDLM_AIX/hdlmtool/instutil/installhdlm -f /
any-directory
/
installation-information-settings-file
Even though a message asking you to restart the host is displayed during
installation, you do not have to restart the host.
During installation, the
KAPL09241-W
message might be output. In this case,
installation of HDLM continues, but installation of HDLM components has
failed. After installing HDLM, resolve the problem according to the
KAPL09241-W
message if necessary.
When installation is successful, the
KAPL09211-I
message is output and the
host restarts. After the host has restarted, check to make sure that the settings have
been updated as specified in the installation information settings file.
Note that, if the upgrade installation or re-installation ends in an error, HDLM
may no longer be installed at all. In this case, proceed to step 12.
If unattended installation ends normally, proceed to step 13.
12. If HDLM was not upgraded or re-installed properly, perform a new installation of
HDLM.
• When the boot disk is in a single-path configuration
Execute the following command to restart the host, and then perform the new
installation procedure from step 2:
# shutdown -Fr
• When the boot disk is in a multi-path configuration
Execute the following command to shut down the host, and then perform the
new installation procedure from step 1:
# shutdown -F
After performing a new installation of HDLM, set up HDLM again based on the
HDLM settings backed up in step 7.
13. Unmount the DVD-ROM.
# umount /
cdrom