HP Hitachi Dynamic Link Manager Software - Manual (Page 133)

3. Creating an HDLM Environment
111
The files beginning at
hdisk3
are the names of the logical device files
corresponding to the storage system's physical volumes.
After executing the
lspv
command, if there is no
hdisk
other than the one that
constitutes
rootvg
, re-execute the procedure starting from step 14.
16. Execute the
dlnkmgr
command's
view
operation to check the status of each
program:
# /usr/DynamicLinkManager/bin/dlnkmgr view -sys
HDLM Version :
x.x.x
-
xx
Service Pack Version :
Load Balance : on(rr)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(60)
Intermittent Error Monitor : off
HDLM Manager Ver WakeupTime
Alive
x.x.x
-
xx yyyy
/
mm
/
dd hh
:
mm
:
ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive
x.x.x
-
xx yyyy
/
mm
/
dd hh
:
mm
:
ss
4000
HDLM Driver Ver WakeupTime
Alive
x.x.x
-
xx yyyy
/
mm
/
dd hh
:
mm
:
ss
License Type Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation
name = view, completion time =
yyyy
/
mm
/
dd hh
:
mm
:
ss
Even when cluster software is being used, the name of the cluster software is not
displayed in
Support Cluster
. However, the cluster support function is
operating normally.
17. From the execution result of the
view
operation, check that the correct version of
HDLM is installed.
If
HDLM Version
is x.x.x
-
xx, the installed version of HDLM is correct. x.x.x
-
xx
is the installed version of HDLM.
If the KAPL01012-E message is displayed, the HDLM device has not been
configured. Re-execute the procedure starting from step 14.
18. From the execution result of the
view
operation, check that the programs are