HP Hitachi Dynamic Link Manager Software User Manual
Page 267

6. Command Reference
245
# /usr/DynamicLinkManager/bin/dlnkmgr view -cha
For details about how to execute the
view
operation to display the CHA port IDs,
see (5) To Display CHA Port Information in 6.7.2 Parameters.
Example
The following example shows how to place online all paths connected to the
CHA port whose CHA-port-ID is
00001.
# /usr/DynamicLinkManager/bin/dlnkmgr offline -chaid
00001
KAPL01104-I All the paths which pass the specified CHA
port will be changed to the Online status. Is this OK?
[y/n]:y
KAPL01061-I 15 path(s) were successfully placed Online;
0 path(s) were not. Operation name = online
#
-pathid
AutoPATH_ID
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by using
the
view
operation. For details about the
view
operation, see 6.7 view (Displays
Information). Leading zeros can be omitted (
000001
and
1
indicate the same
AutoPATH_ID); however, when the target AutoPATH_ID is
000000
, enter
000000
or
0
for the parameter value.
AutoPATH_IDs are re-assigned every time the host is restarted. When you want
to add a new LU without restarting the host, AutoPATH_IDs are re-assigned to
each path of the LU when you execute the
cfgmgr
command. Always make sure
that you use the
view
operation to find the current AutoPATH_ID of the target
path, before executing the
online
operation.
-hdev
host-device-name
[-ospathid
OS-management-path-ID
]
Use this parameter to place online path connected to the specified host device. If
the
-ospathid
parameter is not specified, path with the specified host device
name are placed online.
For host-device-name, specify the value of
HDevName
.
For OS-management-path-ID, specify the value of
OSPathID
. Leading zeroes
can be omitted from the OS management path ID (
00001
and
1
are the same
value).
To display
HDevName
and
OSPathID
, execute the
view
operation as follows: