HP Hitachi Dynamic Link Manager Software - Manual (Page 162)

3. Creating an HDLM Environment
140
on
specifies that intermittent error monitoring is to be used. To disable intermittent
error monitoring, specify
off
. When you set this parameter to
on
, you can specify
intermittent error conditions by using the
-intvl
and
-iemnum
parameters. Specify
the monitoring interval for an intermittent error in the
-intvl
parameter, and the
number of times that the error needs to occur in the
-iemnum
parameter. When these
parameters are omitted, the default values of 210 and 3 are used, respectively.
(5) Setting the Error Log Collection Level
The error log (the HDLM manager log (
dlmmgr
n
.log
(n indicates a file number from
1
to
16
)) collection level can be set.
Table 3-15: Values for the Error Log Collection Level Setting lists and describes
values for the error log collection level setting.
Table 3-15: Values for the Error Log Collection Level Setting
If an error occurs, you might have to set the error log collection level to 1 or higher to
collect any log information.
The higher this value is set, the more information that will be output. As the amount of
log information to be output increases, it will take less time to overwrite the old error
log information with the new information.
The following is an example of setting up the error log collection level by using a
command:
# /usr/DynamicLinkManager/bin/dlnkmgr set -ellv 2
Specify the error log collection level as a number.
(6) Setting the Trace Level
The trace output level can be set.
Value Description
0 No error logs are collected.
1 All information for errors of the "Error" level or higher is
collected.
2 All information for errors of the "Warning" level or higher is
collected.
3 All information for errors of the "Information" level or
higher is collected.
4 All information for errors of the "Information" level or
higher (including maintenance information) is collected.