HP Hitachi Dynamic Link Manager Software - Manual (Page 124)

3. Creating an HDLM Environment
102
12. For a re-installation, execute the following command:
• When installing HDLM from the DVD-ROM
# /
directory-in-which-the-DVD-ROM-is-mounted
/installux.sh
or
# installp -aXFd
/directory-in-which-the-DVD-ROM-is-mounted
/
HDLM_AIX all
• When installing HDLM from the directory to which the DVD-ROM was
copied
# /
directory-copied-from-DVD-ROM
/installux.sh
or
# installp -aXFd /
directory-copied-from-DVD-ROM
/HDLM_AIX all
Even though a message asking you to restart the host is displayed during
installation, you do not have to restart the host.
If you execute the
dlmrmdev
utility without the
-e
parameter specified at step 3
or 7 and then the
KAPL09048-E
message is displayed, the hdisk for the device
that is managed by HDLM still remains.
If you execute the
dlmrmdev
utility with the
-e
parameter specified at step 3 or
7 and then the
KAPL09048-E
message is displayed, the hdisk for the device that
is managed by HDLM still remains, and its status is
Available
. Re-execute the
procedure in step 3.
During installation, the
KAPL09241-W
message might be output. In this case,
installation of HDLM continues, but installation of HDLM components has
failed. After installing HDLM, resolve the problem according to the
KAPL09241-W
message if necessary.
13. Execute the following command to make sure that the package is installed.
# lslpp -la DLManager.mpio.rte
Make sure that the fileset item in the output listing contains
DLManager.mpio.rte
, and all the displayed statuses are
COMMITTED
.
If one or more of the displayed statuses are
BROKEN
, uninstall and then re-install
HDLM.
14. Execute the following command to make sure that the hdisk.
# cfgmgr