HP Hitachi Dynamic Link Manager Software User Manual
Page 110

3. Creating an HDLM Environment
88
x.x.x
-
xx is the installed version of HDLM.
24. From the execution result of the
view
operation, check that the programs are
running properly.
If
HDLM Manager
,
HDLM Alert Driver
, and
HDLM Driver
are all
Alive
, all
programs are running correctly.
If you are not using a virtual I/O server, go to step 28.
25. If you are using a virtual I/O server, define an hdisk as a virtual target device.
Execute the following command on the virtual I/O server:
When creating the hdisk as a virtual target device:
$ mkvdev -vdev
hdisk-name
-vadapter
virtual-SCSI-server-adapter-name
When creating the logical volume as a virtual target device:
$ mkvdev -vdev
logical-volume-name
-vadapter
virtual-SCSI-server-adapter-name
26. Execute the following command in the client logical partition to reconfigure the
device:
# cfgmgr
27. Execute the following command in the client logical partition to confirm that the
physical volume has been recognized as hdisk.
If the following message is displayed, then the physical volume (hdisk) was
recognized correctly:
# lsdev -Cc disk
hdisk1 Available Virtual SCSI Disk Drive
28. Activate the volume group used by HDLM.
# varyonvg
volume-group-name
29. Mount the file system used by HDLM.
# mount
file-system-mount-point