HP Hitachi Dynamic Link Manager Software - Manual (Page 175)

3. Creating an HDLM Environment
153
When you specify a monitoring interval of 0 in 6: Lookout span, the value set in
New Max (sec) will be disregarded.
Also, when you specify a value of 0 for New Max (sec), even if you specify the
monitoring interval in 6: Lookout span, the maximum number of messages
output will not be adjusted.
To leave the maximum number of messages output as is, leave New Max (sec)
blank, enter
!
and press the Enter key. You will be returned to the Hitachi
Network Objectplaza Trace Library setup menu.
6. Press the Enter key.
The new setting is applied and the Hitachi Network Objectplaza Trace Library
setup menu appears again.
3.8.7 Finishing the Hitachi Network Objectplaza Trace Library
Settings
This section explains how to close the Hitachi Network Objectplaza Trace Library
setup menu when you are finished.
1.
In the Hitachi Network Objectplaza Trace Library setup menu, type
e
and press
the Enter key.
You will be asked to if you want to save the new settings.
2. To save the new settings, click
Yes
, otherwise, click
No
.
3.8.8 Applying the Hitachi Network Objectplaza Trace Library
Settings
To apply the settings, after you change the amount of integrated trace information by
using Hitachi Network Objectplaza Trace Library:
1.
Log in as a user with root permissions.
2. Execute the following command to check the programs using HNTRLib2.
In the following example, only HDLM uses HNTRLib2.
# /opt/hitachi/HNTRLib2/etc/hntr2dgetname