HP Hitachi Dynamic Link Manager Software - Manual (Page 150)

3. Creating an HDLM Environment
128
# /cdrom/HDLM_AIX/hdlmtool/instutil/installhdlm -f /
any-directory
/
installation-information-settings-file
Even though a message asking you to restart the host is displayed during
installation, you do not have to restart the host. When installation is successful,
the
KAPL09211-I
message is output.
During installation, the
KAPL09241-W
message might be output. In this case,
installation of HDLM continues, but installation of HDLM components has
failed. After installing HDLM, resolve the problem according to the
KAPL09241-W
message if necessary.
For an upgrade installation or re-installation of HDLM, the configuration of the
existing hdisks recognized as HDLM management-target devices is inherited.
10. Unmount the DVD-ROM.
# umount /
cdrom
11. Delete the created mount directory.
# rm -r /
cdrom
12. Delete the installation information settings file.
# rm -r /
directory-containing-the-installation-information-settings-file
13. Perform the procedure appropriate for the installation type.
If you are performing a new installation, perform steps 14 to the end of the
procedure described in (1) When Installing HDLM in a Local Boot Disk
Environment of 3.5.3 Performing a New Installation of HDLM.
If you are performing an upgrade installation or a re-installation, perform steps 15
to the end of the procedure described in (1) When Installing HDLM in a Local
Boot Disk Environment of 3.5.5 Performing an Upgrade Installation or
Re-installation of HDLM.
(2) When Installing HDLM in a Boot Disk Environment
To install HDLM in a boot disk environment:
1.
Use a single-path configuration for host and storage systems.