HP Hitachi Dynamic Link Manager Software - Manual (Page 188)

3. Creating an HDLM Environment
166
3. Execute the following command for the file system used to configure volume
groups in the client logical partition:
# mount
file-system-mount-point
4. Execute the following command to back up the volume group in the client logical
partition:
# savevg -i -f
any-file-name-or-device-volume-name volume-group-name
5. Execute the following command to unmount the file system in the client logical
partition:
# umount
file-system-mount-point
6. Execute the following command to delete the volume group in the client logical
partition:
# reducevg -df
volume-group-name hdisk-name
7. Execute the following command to delete the virtual SCSI disk in the client
logical partition:
# rmdev -dl
hdisk-name
8. Execute the following command to delete the virtual target device on the virtual
I/O server:
$ rmdev -dev vtscsin
9. Stop all processes and services that use the HDLM management-target paths.
Stop any process or service of an application, such as a DBMS, that is using the
HDLM management-target path.
For details about the stopping method, see the manual for each application.
10. Specify the
-A
parameter, as required, and execute the
dlmrmdev
utility to
remove HDLM drivers.
When you specify the
-A
parameter and execute the
dlmrmdev
utility, you can
skip steps 11 through 14. When
dlmrmdev
is executed, a message appears asking