HP Hitachi Dynamic Link Manager Software - Manual (Page 363)

7. Utility Reference
341
• For a new installation:
The default value will be used.
• For an upgrade installation or re-installation:
The previous setting will be inherited.
#1
Enter one key and one setting per line.
#2
If the value is not of an allowable type, an error will occur.
For details about the functions set by these keys, see 7.7 dlmodmset Utility for
Setting the HDLM Execution Environment ODM.
[ENVIRONMENT_SETTINGS] section
This section defines information that is used when the
set
operation of the HDLM
command is executed. This section is optional. If this section name is omitted, or if any
of the keys in the section are not defined, setup by means of the
set
operation of the
HDLM command will not be executed.
For details on the
set
operation, see 6.6 set (Sets Up the Operating Environment).
Table 7-8: Keys in the [ENVIRONMENT_SETTINGS] Section lists the keys defined
in the
[ENVIRONMENT_SETTINGS]
section.
Table 7-8: Keys in the [ENVIRONMENT_SETTINGS] Section
Key name #1 Description #2 Necessity of
definition
Maxim
um
numbe
r of
charac
ters
New
installat
ion
Upgrad
e
installat
ion or
re-insta
llation
load_balance
Specify one of the following values to
indicate whether to enable or disable the
load balancing function:
on
: Enabled (default)
off
: Disabled
Optional Optional 3