HP Hitachi Dynamic Link Manager Software - Manual (Page 140)

3. Creating an HDLM Environment
118
unique_id : off
HDLM Subclass : node
KAPL10800-I The dlmodmset utility completed normally.
#
If the
unique_id
value is
on
, the
unique_id
method is being used. If it is
off
,
the PVID method is being used. If the
unique_id
method is being used, proceed
to step 8.
3. Execute the following command to activate the volume group that is using the
virtual SCSI disk of the HDLM management-target hdisk:
# varyonvg
volume-group-name
4. Execute the following command to mount the file system (under control of the
volume group) in the client logical partition:
# mount
file-system-mount-point
5. Execute the following command to back up the volume group in the client logical
partition:
# savevg -i -f
any-file-name-or-device-volume-name volume-group-name
6. Execute the following command to unmount the file system in the client logical
partition:
# umount
file-system-mount-point
7. Execute the following command to delete the volume group in the client logical
partition:
# reducevg -df
volume-group-name hdisk-name
8. Execute the following command to delete the virtual SCSI disk in the client
logical partition:
# rmdev -dl
hdisk-name
9. Execute the following command to delete the virtual target device in the virtual I/