3 checking the updated settings – HP Hitachi Dynamic Link Manager Software User Manual

Page 167

3. Creating an HDLM Environment

145

This example shows how to specify the audit log facility:

# /usr/DynamicLinkManager/bin/dlnkmgr set -audfac local0

3.7.3 Checking the Updated Settings

This chapter describes steps involved in how to check the updated settings by using the

dlnkmgr

command's

set

operation after settings have been changed.

When you change some settings, you can display information about all of HDLM

function settings. The following is an example of executing the command:

# /usr/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version :

x.x.x

Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 2
Elog File Size(KB) : 1000
Number Of Elog Files : 5
Trace Level : 1
Trace File Size(KB) : 2000
Number Of Trace Files : 10
Path Health Checking : on(10)
Auto Failback : on(10)
Intermittent Error Monitor : on(2/20)
KAPL01001-I The HDLM command completed normally. Operation name
= view, completion time =

yyyy

After you have set up the collection of audit log data, use the following command to

make sure that the setting has been specified correctly:

local1

local2

local3

local4

local5

local6

local7

Value

Corresponding facility value in the /etc/syslog.conf file