HP Hitachi Dynamic Link Manager Software User Manual
Page 166

3. Creating an HDLM Environment
144
Table 3-18: Values Indicating Audit Log Data Categories describes the values that
indicate audit log data categories. The default is
all
.
Table 3-18: Values Indicating Audit Log Data Categories
This example shows how to enable the collection of audit log data:
# /usr/DynamicLinkManager/bin/dlnkmgr set -audlog on -audlv 6
-category all
Specify
on
if you want to collect audit log data, and
off
if you do not want to collect
audit log data. If you specify
on
, you can use the
-audlv
parameter to specify the
collection level for audit log data and the
-category
parameter to specify the audit
log categories.
If you want to set the audit log facility, see (12) Setting the Audit Log Facility.
(12) Setting the Audit Log Facility
The following describes how to specify the output destination for audit log data.
If you want to specify the output destination for audit log data, first specify the audit
log facility by using the
dlnkmgr
set
-audfac
command. Next, define the output
destination of the facility in the
/etc/syslog.conf
file. Table 3-19: Values
Indicating Audit Log Facility describes the values that indicate audit log facility. The
default is
user
.
Table 3-19: Values Indicating Audit Log Facility
7
Value
Explanation
ss
Audit log events of the
StartStop
category are collected.
a
Audit log events of the
Authentication
category are collected.
ca
Audit log events of the
ConfigurationAccess
category are collected.
all
Audit log events of the
StartStop
,
Authentication
, and
ConfigurationAccess
categories
are all collected.
Value
Corresponding facility value in the /etc/syslog.conf file
user
or
1
user
local0
or
16
local0
Value (severity)
Explanation