HP Hitachi Dynamic Link Manager Software User Manual
Page 260

6. Command Reference
238
port will be changed to the Offline(C) status. Is this
OK? [y/n]:y
KAPL01056-I If you are sure that there would be no problem
when all the paths which pass the specified CHA port are
placed in the Offline(C) status, enter y. Otherwise,
enter n. [y/n]:y
KAPL01061-I 2 path(s) were successfully placed
Offline(C); 0 path(s) were not. Operation name = offline
#
-chaid
CHA-port-ID
Use this parameter to place offline, at one time, all paths that pass through a
specific CHA port. The command will place offline all paths connected to the
CHA port that has the specified CHA-port-ID. To display the CHA port IDs,
execute the following
view
operation:
# /usr/DynamicLinkManager/bin/dlnkmgr view -cha
For details about how to execute the
view
operation to display the CHA port IDs,
see (5) To Display CHA Port Information in 6.7.2 Parameters.
Example
The following example shows how to place offline all paths connected to the
CHA port whose CHA-port-ID is
00001.
# /usr/DynamicLinkManager/bin/dlnkmgr offline -chaid
00001
KAPL01102-I All the paths which pass the specified CHA
port will be changed to the Offline(C) status. Is this
OK? [y/n]:y
KAPL01103-I If you are sure that there would be no problem
when all the paths which pass the specified HBA port are
placed in the Offline(C) status, enter y. Otherwise,
enter n. [y/n]:y
KAPL01061-I 15 path(s) were successfully placed
Offline(C); 0 path(s) were not. Operation name = offline
#
-pathid
AutoPATH_ID
Use this parameter to place a single path offline.
Specify the current AutoPATH_ID of the target path, which is displayed by using
the
view
operation. For details about the
view
operation, see 6.7 view (Displays
Information). Leading zeros can be omitted (
000001
and
1
indicate the same
AutoPATH_ID); however, when the target AutoPATH_ID is
000000
, enter
000000
or
0
for the parameter value.