HP Hitachi Dynamic Link Manager Software User Manual
Page 192

3. Creating an HDLM Environment
170
2.
Execute the following command to activate the volume group that is using the
virtual SCSI disk of the HDLM management-target hdisk:
# varyonvg
volume-group-name
3.
Execute the following command to mount the file system used to configure
volume groups in the client logical partition:
# mount
file-system-mount-point
4.
Execute the following command to back up the volume group in the client logical
partition:
# savevg -i -f
any-file-name-or-device-volume-name volume-group-name
5.
Execute the following command to unmount the file system in the client logical
partition:
# umount
file-system-mount-point
6.
Execute the following command to delete the volume group in the client logical
partition:
# reducevg -df
volume-group-name
hdisk-name
7.
Execute the following command to delete the virtual SCSI disk in the client
logical partition:
# rmdev -dl
hdisk-name
8.
Execute the following command to delete the virtual target device in the virtual I/
O server:
$ rmdev -dev vtscsin
If the boot disk is in a single-path configuration, proceed to step 12.
9.
If the boot disk is in a multi-path configuration, execute the following command
to shut down the host.