HP 3PAR Operating System Software - Manual (Page 49)

Description Field Group
Name of device that the port is connected to, e.g. host1, cage0. Connected Device
Port firmware mode setting. Ports in Initiator mode are connected
to drive cages and ports in Target mode export to hosts. Mode
Suspended mode is for target ports that have not yet been
initialized by the system (rare). Peer mode is for Ethernet ports.
Current state of the port. State
The Media Access Control address for the Ethernet interface. MAC IP Settings
IP address of the RCIP port. IP Address
The address of a local IP router on the same network as the
system, used to forward traffic to destinations beyond the local
network. Gateway
Netmask address for the RCIP interface. Subnet Mask
Maximum Transmission Unit. The greatest amount of data or
"packet" size that can be transferred at one time over a particular MTU
network connection without overburdening the connection. The
default MTU setting for an iSCSI port is 1500. When supported
by the network, an MTU value of 9000 should be used.
The duplex speed, Half or Full. Configured Rate
Model of the adapter that contains the port (for example, Intel
PRO/1000MT). Duplex
The TCP port number used by the iSCSI or RCIP card. Adapter Type
The throughput in KB/sec. Total Data Throughput Resources
Viewing SAS Details
If the system supports SAS cages, an SAS tab will be displayed in the Management Window. SAS
ports accept disk attachments only.
To view SAS details:
1.
Access the Ports screen.
2. In the Management Window, click the SAS tab.
Viewing System Ports 49