List pane – HP 3PAR Operating System Software User Manual
Page 27
The Summary tab is divided into a list pane and a detail pane. The list pane displays a summary
of all system ports. The detail pane displays detailed information about a single port selected from
the list pane.
NOTE:
Port states indicating Loss Sync cannot be distinguished between being disconnected and
a bad connection. The default display is a normal icon indicating the port is healthy. You can set
the port feature to indicate a failed icon in the event of a Loss Sync as follows:
1.
Go to the View menu.
2.
Select Preferences and the Advanced tab.
3.
Check the Display ports in Loss Sync state as failed checkbox.
List Pane
The list pane provides the following information:
Description
Column
Port location in Node:Slot:Port format.
Position
The designated port label.
Label
World Wide Name or Media Access Control address of the connected device.
WWN/MAC
The state of the port. See
“System and Component Status Icons” (page 409)
State
Indicates whether the port is FC, iSCSI, RCIP, or RCFC.
Type
Type of device that the port is connected to. Free, Disk, Host, Peer, RC, or InServ.
Connected Device Type
Name of device that the port is connected to, e.g., host1, cage0.
Connected Device
Port firmware mode setting—Initiator, Target, Peer, or Suspended. Ports in Initiator mode
are connected to drive cages and ports in Target mode export to hosts. Suspended
Mode
mode is for target ports that have not yet been initialized by the system (rare). Peer
mode is for Ethernet ports.
Viewing System Ports
27