HP 3PAR Operating System Software - Manual (Page 48)

The RCIP tab is divided into a list pane and a detail pane. The list pane displays a summary of all
RCIP ports in the system. The detail pane displays detailed information about a single port selected
from the list pane.
The list pane provides the following information:
Description Column
The port location in Node:Slot:Port format. Position
Media Access Control address of the connected device. MAC
The state of the port. See “System and Component Status Icons” (page 409) . State
IP address of the RCIP port. IP Address
Netmask address for the RCIP interface. Subnet Mask
The address of a local IP router on the same network as the Storage System, used to
forward traffic to destinations beyond the local network. Gateway
Maximum Transmission Unit. The greatest amount of data or "packet" size that can be
transferred at one time over a particular network connection without overburdening the MTU
connection. The default MTU setting for an iSCSI port is 1500. When supported by the
network, an MTU value of 9000 should be used.
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or 4 Gbps). When
there is no specified value, no connection exists. Rate
The detail pane provides the following information:
Description Field Group
The port location in Node:Slot:Port format. Position General
The designated port label. Label
Indicates whether the port is FC, iSCSI, RCIP, or RCFC. Type
Rate that data can be transferred over the port (1 Gbps, 2 Gbps
or 4 Gbps). When there is no specified value, no connection
exists. Rate
Type of device that the port is connected to. Free, Disk, Host,
Peer, or InServ. Connected Device Type
48 Managing Ports