HP 3PAR Operating System Software - Manual (Page 216)

Description Field Group
Type of device that the port is connected to. Free,
Disk, Host, Peer, or InServ. Connected Device Type
Name of device that the port is connected to, e.g.
host1, cage0. Connected Device
Port firmware mode setting. Ports in Initiator mode
are connected to drive cages and ports in Target Mode
mode export to hosts. Suspended mode is for target
ports that have not yet been initialized by the system
(rare). Peer mode is for Ethernet ports.
Current state of the port. State
The Media Access Control address for the Ethernet
interface. MAC IP Settings
IP address of the RCIP port. IP Address
The address of a local IP router on the same network
as the Storage System, used to forward traffic to
destinations beyond the local network. Gateway
Netmask address for the RCIP interface. Subnet Mask
Maximum Transmission Unit. The greatest amount of
data or "packet" size that can be transferred at one MTU
time over a particular network connection without
overburdening the connection. The default MTU
setting for an iSCSI port is 1500. When supported
by the network, an MTU value of 9000 should be
used.
The duplex speed, Half or Full. Configured Rate
Model of the adapter that contains the port (for
example, Intel PRO/1000MT). Duplex
The TCP port number used by the iSCSI or RCIP card. Adapter Type
The throughput in KB/sec. Total Data Throughput Resources
RCFC Tab
The RCFC tab displays a summary of all Remote Copy over Fibre Channel (RCFC) ports on a system.
216 Configuring and Managing Remote Copy