Inventory tab – HP 3PAR Operating System Software User Manual
Page 218
Description
Field
Group
Rate that data can be transferred over the port (1 Gbps, 2 Gbps or
4 Gbps). When there is no specified value, no connection exists.
Rate
Type of device that the port is connected to. Free, Disk, Host, Peer,
or InServ.
Connected Device Type
Name of device that the port is connected to, e.g. host1, cage0.
Connected Device
Port firmware mode setting. Ports in Initiator mode are connected to
drive cages and ports in Target mode export to hosts. Suspended
Mode
mode is for target ports that have not yet been initialized by the
system (rare). Peer mode is for Ethernet ports.
Current state of the port.
State
The throughput in KB/sec.
Total Data Throughput
Resources
The type of port connection.
Connection Mode
Settings
Connection type or port connection setting (Loop, Point, or
Loop-point). When the port is set to Loop-point, both loop and
point-to-point connections are enabled.
Connection Type
Data transfer rate setting (for example, 1 Gbps). Auto indicates that
the system automatically selects the rate.
Configured Rate
Maximum rate of connection from the port.
Max Rate
Indicates whether Fibre Channel service Class 2 is Disabled, Ack 1
or Ack 0.
Class 2
For fabric attached ports, indicates the VLUN change notification
setting. When set to Enabled, notices are generated and sent to the
fabric controller. When set to Disabled, no notification is sent.
VCN
Indicates whether the node's WWN is Enabled or Disabled.
Unique Node WWN
If Disabled, each I/O generates a separate interrupt to the HBA port
driver rather than generating one interrupt for multiple I/O
completion.
Interrupt Coalesce
Type of connection (Private Loop, Public Loop, or Point-Point).
Topology
Fibre Channel Settings
Identifies which Fibre Channel classes of service are enabled (2, 3,
or 2/3). 2/3 indicates that both Class 2 and Class 3 are enabled.
Class
Model of the Fibre Channel adapter that contains the port (for
example, QLOGIC 2302).
Adaptor Type
World Wide Name of the remote port.
Remote Port WWN
World Wide Name of the remote node.
Remote Node WWN
Indicates whether port mode change from initiator to target or vice
versa is Allowed or Prohibited. This setting is configured using the
HP 3PAR CLI command controlport.
Mode Change
The state of the link.
Link State
Inventory Tab
The Inventory tab displays information about the Remote Copy ports on a system such as the ports'
manufacturer and firmware version. The list pane of the Inventory tab displays summary information
about the system's RCFC and RCIP ports. The detail pane displays details about a selected RCFC
or RCIP port from the list pane. For information about the detail pane, see
and
.
218
Configuring and Managing Remote Copy