HP XP Command View Advanced Edition Software - Manual (Page 178)

Performing Storage Subsystem Operations 178
4. Make the desired channel adapter mode changes, and select OK.
5. Before changing the fibre PCB mode, Device Manager displays a warning that you cannot change the
fibre PCB mode while I/O operations with the host are underway. You must stop the host, change the
fibre PCB mode, and then restart the host.
After reviewing the information displayed in the warning message and stopping the hosts, select OK. To
cancel your request to change the fibre PCB mode, select CANCEL.
6. When the confirmation panel displays (see Figure 10-29 ), review the changes carefully. Select YES to
change the modes or NO to cancel your request.
You are notified when the operation is complete. You can now restart the host(s).
Figure 10-28 Changing the Channel Adapter Mode (XP1024/XP128)