HP XP Command View Advanced Edition Software - Manual (Page 108)

All Storage/My Storage Operations 108
Figure 8-5 Viewing the Mainframe-Unspecified Group for a Storage Subsystem
Table 8-3 Information for the Mainframe-Unspecified Group under All Storage/My Storage
Item Description
LDEV Displays the LDEV number. For LUSE, only a representative LDEV number is displayed. Select
the link to display the Detailed Information panel for the LDEV (refer to
Figure 7-7 ).
This item can be used for filtering. You can set conditions for filtering by specifying a range.
Type Displays the LDEV type. This column is displayed for StorageWorks XP12000/XP10000 only.
•
#AT = Internal volume to which an external volume is mapped, and the external volume
consists of SATA drives
•
#BD = Internal volume to which an external volume is mapped, and the external volume
consists of BD drives
•
#-
= Internal volume to which an external volume is mapped, and the drive type of the
external volume is not identified
•
-
= LDEVs other than those given above
SLPR Displays the SLPR number. This item is displayed only for a StorageWorks XP12000/XP10000
that can use Disk/Cache Partition. If no SLPR is set, 0 is displayed. If a LUSE is used and
different SLPRs are set for the LDEVs making up the LUSE, Inconsistent is displayed.
CLPR Displays the CLPR number. This item is displayed only for a StorageWorks XP12000/XP10000
that can use Disk/Cache Partition. If no CLPR is set, 0 is displayed. If a LUSE is used,
Inconsistent
is displayed in either of the following cases:
• When different SLPRs are set for the LDEVs making up the LUSE
• When different CLPRs are set for the LDEVs making up the LUSE
Note that a blank is displayed if the LDEV is a Snapshot XP V-VOL.
EMU Type Displays the emulation type. For LUSE, this item indicates the emulation type and the number of
LDEVs in the LUSE.
Capacity Displays the LDEV capacity. The unit is Cyl.