HP XP Command View Advanced Edition Software User Manual
Page 155
Performing Storage Subsystem Operations 155
belonging to the representative VDEV. No information displays for array groups that do not belong to the
representative VDEV.
For a discrete VDEV configuration, the Frame Information panel displays the information shown in
Figure
10-11
.
NOTE:
For a 7D+1P array group, Coupled displays next to the parity group number (Parity Group
1-2(Coupled:2-2)
). In this case, information about the parity group indicated by Coupled
(example: 2-2) is not displayed (see
Figure 10-9
).
8.
In the Frame Information (level 1) panel, you can select the desired array group to open the Frame
Information (level 2) panel (see
Figure 10-12
).
9.
In the Frame Information (level 2) panel, you can select the desired array group to open the LDEV
Information panel. For details on this panel, see section
10-2-4
.
10.
In the physical view, click the DISKS button to view the disk information (see
Figure 10-13
).
Figure 10-7
Physical View for StorageWorks XP1024/XP128 (Configuration)
The StorageWorks XP1024/XP128 physical view (Configuration) panel displays the following information and
buttons:
•
Model: the type (vendor model) of the storage subsystem, such as XP128
•
Serial: the (vendor) serial number of the storage subsystem
•
IP Address: the IP address of the storage subsystem
•
Microcode SVP: the microcode level of the service processor
•
Microcode DKC: the microcode level of the disk controller
•
Configured Capacity: the configured capacity of the storage subsystem (the total capacity of all LDEVs,
not the total capacity of the physical disks). The Configured Capacity increases or decreases when
logical devices are created or deleted.
•
Total Cache: the total cache capacity of the storage subsystem
•
PORT CONTROLLERS button: opens the Port Controller panel (see section
10-3-4
)
•
Port buttons (such as E under Cluster 1 for port CL1 E): open the Port Information panel for the selected
port (see section
10-3
)
NOTE:
The following ports are not displayed: CL1-S, CL1-T, CL1-U, CL1-V, CL1-W, CL1-X, CL1-Y,
CL1-Z, CL2-S, CL2-T, CL2-U, CL2-V, CL2-W, CL2-X, CL2-Y, CL2-Z.
NOTE:
If you use disk units of StorageWorks XP512/XP48 for StorageWorks XP1024/XP128, the
physical view displays six disk units (three units on each side) in total in the maximum configuration.