HP XP Command View Advanced Edition Software - Manual (Page 136)

Performing Host Operations 136
5. Select Modify Pair(s) Step. The Select Modify Pair(s) panel (see Figure 9-21 ) allows you to select the
copy group(s) and/or copy pair(s) for which you want to modify the status. When you are finished
selecting copy groups/pairs, select Next.
NOTE: You can only perform one type of operation at a time (split, resync, or restore), so make sure to
select copy groups/pairs for one operation type only.
6. Modify Pair(s) Step. The Modify Pair(s) panel (see Figure 9-22 ) allows you to select the desired
Operation (split, resync, or restore) and Copy Pace for the selected copy group(s)/pair(s). When you are
finished selecting the operation and copy pace for the pair(s), select Finish.
Operation: Select Split, Resync, or Restore. For requirements on performing the Split, Resync, and
Restore operations, see
Table 9-1 . For requirements on performing Split, Resync, and Restore
operations for Business Copy XP cascade pairs, see Table 9-2 .
Copy Pace: Instead of the displayed current value for the copy pace, select the changed value: Slower,
Medium, or Faster for StorageWorks XP Disk Array; 1 through 15 for other storage subsystems.
You cannot change the value for the copy pace if:
• Split is selected from Operations for Continuous Access XP.
• A setting other than Restore is selected from Operations for Snapshot XP.
NOTE: If you want to change the status of a StorageWorks XP Disk Array Business Copy XP copy pair
whose S-VOL is a P-VOL for Continuous Access XP, the status of the Continuous Access XP pair must
be “Split”.
NOTE: The Copy Pace value does not appear for a copy pair that was created using other
management tools (such as Remote Web Console or SVP) or that was created by another Device
Manager server. If you use any other management tool to modify the Copy Pace value, the modified
value will not be applied.
7. Summary of Changes Step. The Summary of Changes panel (see Figure 9-23 ) displays the requested
modify pair operation(s) and asks you to confirm the operation(s). If you selected a copy group, ALL
PAIRS
displays for Pair.
Review the operation(s) carefully, and select Confirm to confirm the operation(s), or select Cancel to
cancel your request. If you need to make any changes, select Back to return to the previous panel(s).
8. If you selected the split operation, Device Manager warns you that the data on the S-VOL may not be
complete if you split a pair during I/O processing on the P-VOL (see
Figure 9-24 ). Read the warning
carefully, and select OK if there is no problem, or select Cancel to cancel your request to split the pair(s).
You are notified when the modify copy pair operation is complete.