Yokogawa DAQWORX User Manual
Wx103 mxlogger, User’s manual
This manual is related to the following products:
Table of contents
Document Outline
- Software License Agreement
- Contents
- Chapter 1 Before Using the Software
- Chapter 2 Logger
- 2.1 Searching MX100 Data Acquisition Units and Configuring the Network
- 2.2 Configuring the System
- Selecting the MX100s That Are to Monitor the Data
- Retrieving/Setting Module Configuration Information
- Assigning Input Modules to Measurement Groups
- Configuring a System Using MX100s That Are Not Connected
- Setting the A/D Integration Time
- Setting the Temperature Unit for TC and RTD
- MX100 Response Check
- CF Card Information
- Setting the Write Mode of the CF Card
- 2.3 Setting the Data Acquisition Conditions
- 2.4 Setting the Measurement Conditions (Measurement Channel Settings)
- Setting the Input Mode
- Setting the Measuring Range
- Setting the Span
- Setting the Scale (Only When Scaling)
- Setting the Reference Channel for Difference Input (Valid Only When Measuring the Difference with Respect to the Measured Value of the Reference Channel)
- Setting the Remote RJC Reference Channel (Valid Only When the Input Mode Is Set to RRJC (TC))
- Setting the Unit, Tag Number, and Tag Comment
- Setting the Time Constant of the First-Order Lag Filter (Valid Only When the Input Mode Is Set to Something Other than DI)
- Setting the Burnout (Valid Only When the Input Mode Is Set to TC)
- Setting the RJC (When the Input Mode Is Set to TC)
- Setting the Initial Balancing for Strain Input Channels (Only When the Input Mode Is Set to STR)
- Importing Tag Numbers and Tag Comments
- When Setting the Measurement Conditions for Each Channel Individually
- 2.5 Setting Computations (Setting the Computation Channels)
- Setting the Expression
- Setting the Span
- Setting the Unit, Tag Number, and Tag Comment
- Setting the User-Defined Constant
- Importing Expressions
- Importing User-Defined Constants
- Importing Tag Numbers and Tag Comments
- Setting Timers (Only When Using Timers in the Computations)
- When Calculating ±Overrange Values of Measurement Channels as the Maximum or Minimum Value of the Measurement Range
- Resetting Computation
- When Setting Computations for Each Channel Individually
- 2.6 Setting Alarms
- 2.7 Digital Output
- 2.8 Analog/PWM Output Settings
- 2.9 Event Processing
- 2.10 Starting/Stopping Data Monitoring and Displaying the Monitor
- Start Data Monitoring
- Stop Data Monitoring
- Displaying the Trend Monitor Window and Changing Display Settings
- Displaying the Numeric Monitor Window
- Displaying the Meter Monitor Window
- Displaying the All Channel Monitor Window
- Displaying the Alarm Monitor Window
- Changing Display Settings on the General Display Settings Window
- 2.11 Pausing/Resuming the Updating of the Monitor Display and Reading Measured Values Using Cursors
- 2.12 Starting and Stopping Data Recording
- 2.13 Saving/Loading and Printing Setup Data (Project)
- 2.14 Setting Up the Monitor Server
- 2.15 Setting Up the DDE Server
- 2.16 Displaying the Software Version and Other Information
- Chapter 3 Viewer
- 3.1 Loading Data Files
- 3.2 Setting the Display
- 3.3 Reading Values Using Cursors
- 3.4 Statistical Computation over an Area of Measured/Computed Data
- 3.5 Saving Display Settings
- 3.6 Saving the Display Template
- 3.7 Converting Data Formats
- 3.8 Printing Data
- 3.9 Displaying the Software Version and Other Information
- Chapter 4 Calibrator
- Chapter 5 Troubleshooting
- Index